![]() ![]() Using the GREEN dial, adjust the half flush setting one setting higher.The “Rolling Pin” should be set to “8” which is full flow. Adjust the roller clamp on the refill tube so that it is allowing full flow.Make sure the refill tube (rubber hose) is supplying water down the overflow pipe and not into the tank.Make sure the water level in the toilet bowl is up to its highest capacity.Water level is half way or completely over the oval opening and the full and half flush are working but the bowl is not clearing out. Set the BLUE dial one to two settings higher than that of the GREEN dial.Ģ.This is the lowest possible setting while maintaining a good half flush. Continue this process until toilet does not evacuate the paper and adjust dial up 1 setting.Place 3 pieces of toilet paper in the bowl and flush, if the bowl evacuates the toilet paper, lower the green dial setting by one number and repeat flush.Once water level has been set, set both adjustment dials to maximum setting. ![]() If your water level cannot be increased, the Duo Flush system should not be used. Set water level higher: Water level should be half way to all the way over the oval windows of the Duo Flush valve (See picture below).The Full and / or Half flush closes immediately after tank lever is released. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |